Now attach the desired side of the spigot to the glass panel. Lay the glass horizontally on a surface with a protective covering such as the cardboard from the box of the panel or a blanket. Attach the spigots to the glass. Place rubber inserts on the glass, line up and position in accordance with the required spigot spacing. Dip the rubbers in soapy water if it is difficult to slide the spigot on. Insert the stainless steel pressure plate between the rubber and the inside of spigot and tighten using an Alan key. Ensure there is rubber between the glass and metal; at no stage should the glass touch the metal. Check that the spigot has been attached straight by using a setsquare. Fasten and lock the spigot into position. Place the dress ring on the correct way up and tape into position, preventing the cover plate from falling off when you stand the glass panel into position. You are now ready to erect your panels. Click here to know more about #https://www.avantgardeglass.com.au/diy-glass-pool-fencing/.
No comments:
Post a Comment